Winterizing a rain barrel protects it from freezing damage and ensures it lasts for many seasons. When water freezes, it expands, which can crack plastic barrels, burst fittings, and ruin the spigot. By draining, cleaning, and storing your barrel properly before the first hard freeze, you avoid costly replacements and make spring setup quick and easy.
What You’ll Need
- Garden hose or siphon pump
- Bucket or large container for residual water
- Soft brush or sponge
- Mild dish soap or vinegar
- Clean rag or towel
- Plumber’s tape (thread seal tape)
- Adjustable wrench or pliers
- Optional: food-grade antifreeze (propylene glycol) for the pump if you have one
- Optional: tarp or breathable cover for outdoor storage
Step-by-Step
- Stop the water flow. Disconnect the downspout from the rain barrel’s inlet. If your barrel is connected to a gutter system, redirect the downspout so water flows away from the barrel. This prevents new water from entering while you work.
- Drain the barrel completely. Open the spigot and let gravity do the work. If the barrel sits low, use a garden hose attached to the spigot to siphon water to a lower area. For stubborn water, use a small pump or tip the barrel to pour out the rest. Never leave water sitting in the barrel over winter—even a few inches can freeze and crack the bottom.
- Remove the spigot and fittings. Use an adjustable wrench to unscrew the spigot, overflow fitting, and any hose adapters. Set them aside in a labeled bag so you remember which goes where. If the threads are corroded, apply penetrating oil and wait a few minutes before trying again.
- Clean the interior. Rinse the barrel with a hose to remove sediment and debris. For a deeper clean, scrub the inside with a soft brush and mild dish soap or a vinegar solution (one part vinegar to three parts water). Avoid harsh chemicals—they can leave residues harmful to plants next spring. Rinse thoroughly.
- Dry the barrel. Turn the barrel upside down on a clean surface and let it air dry for at least a day. If you must store it outside, make sure it’s completely dry to prevent mold and mildew. Wipe the outside with a rag.
- Store the barrel. If you have indoor space (garage, shed, basement), move the barrel there. Place it upside down to keep out dust and pests. If storing outdoors, keep it upside down and cover with a tarp or breathable cover. Elevate it on bricks or pallets to avoid standing water underneath.
- Protect the spigot and fittings. Wrap the spigot and other metal parts in a rag or store them in a zip-top bag with a little petroleum jelly to prevent rust. Alternatively, clean them and store them indoors in a dry spot.
- Disconnect and drain any pump. If your rain barrel has a submersible pump, remove it, clean it, and store it indoors. Run propylene glycol antifreeze through the pump according to the manufacturer’s instructions to protect internal seals. Never use automotive antifreeze—it’s toxic to plants and animals.
- Disconnect the downspout diverter. If you have a diverter kit, remove the section that connects to the barrel and cap the downspout opening with a standard downspout cap or a piece of screen to keep leaves and pests out.
- Mark your calendar. Note the date you winterized the barrel. In spring, you’ll need to inspect the barrel for cracks, replace any worn washers, and reattach the spigot with fresh plumber’s tape before reinstalling.
Common Mistakes
- Leaving water in the barrel. Even a small amount of water at the bottom can freeze and expand, causing hairline cracks that leak in spring. Always drain completely.
- Forgetting to disconnect the downspout. If the downspout remains attached, rain and melting snow will refill the barrel, defeating your efforts. Always redirect the downspout.
- Storing the barrel upright. An upright barrel collects water, debris, and pests. Storing it upside down keeps the interior dry and clean.
- Using harsh chemicals to clean. Bleach or strong detergents can leave residues that harm plants and beneficial soil organisms. Stick to mild soap or vinegar.
- Ignoring the spigot. The spigot is often the first part to freeze and crack. Removing and storing it indoors extends its life.
- Not checking for cracks before storing. A small crack can grow during freeze-thaw cycles. Inspect the barrel thoroughly and repair or replace before storing.
Tips
- Do this before the first hard freeze. Ideally, winterize when nighttime temperatures are consistently above freezing. Check your local forecast—if a freeze is coming in a few days, that’s your cue.
- Use a siphon for large barrels. If your barrel is tall or heavy, a siphon hose can drain it without lifting. Start the siphon by filling the hose with water and capping one end, then release.
- Label your parts. Use masking tape to label which fitting goes where. This saves time in spring when you’re reassembling.
- Consider a frost-proof design. Some rain barrels come with a built-in heater or are made of flexible material that can withstand freezing. If you live in a very cold climate, this might be worth investing in next time.
- Use the water wisely. Before draining, use the remaining water on your garden or houseplants. This prevents waste and gives your plants a final drink.
- Store the barrel out of direct sunlight. UV rays can degrade plastic over time. If storing outdoors, keep it in a shaded area or cover it.
Troubleshooting
Water won’t drain completely. If water remains in the bottom, tilt the barrel to pour it out. For a heavy barrel, use a siphon pump or a wet/dry vacuum to remove the last bit. Never leave water behind—it will freeze.
Spigot is stuck. Apply penetrating oil to the threads and wait a few minutes. If it still won’t budge, use a pipe wrench with a cloth to protect the metal. If the spigot is stripped or corroded, replace it—it’s inexpensive and easy to install.
You discover a crack after storing. If the crack is small (less than a few inches), you may be able to patch it with a plastic repair kit designed for outdoor use. However, if the crack is large or the barrel is brittle, it’s safer to replace it. A cracked barrel will leak and can attract mosquitoes.
Mold or mildew inside. If you see mold when you open the barrel in spring, clean it with a vinegar solution (one part vinegar to three parts water) and let it dry thoroughly. Rinse well before reusing.
Pests made a home in the barrel. If you stored the barrel upright and found insects or rodents, clean it out, then store it upside down next time. For extra protection, place a piece of screen over the inlet when you reinstall it in spring.
Frequently Asked Questions
Q: Can I leave my rain barrel out all winter if I drain it?
Yes, you can leave it outside, but it’s risky. Even an empty barrel can crack if water collects in the bottom from rain or snowmelt. If you must leave it out, turn it upside down and cover it. Indoor storage is always safer.
Q: Do I need to remove the spigot?
It’s recommended. The spigot is a common spot for ice to form and crack. Removing it also lets you clean and inspect the threads. If you leave it on, make sure it’s fully drained and open.
Q: What if my rain barrel is made of a flexible material?
Flexible rain barrels (often made of a rubber-like material) can expand slightly when water freezes, but they’re not immune to damage. It’s still best to drain and store them properly. Check the manufacturer’s guidelines for specific winter care.
Q: Can I use antifreeze in my rain barrel?
No—never use automotive antifreeze. It’s toxic to plants, animals, and soil. If you have a pump, use food-grade propylene glycol antifreeze, but only per the pump’s instructions. For the barrel itself, draining is the only safe method.
Q: How do I clean the barrel in spring?
After winter storage, rinse the barrel with a hose, scrub with a soft brush and mild soap, and rinse thoroughly. Check all fittings and replace any worn washers. Reattach the spigot with fresh plumber’s tape to prevent leaks.
Q: What if I live in a mild climate that rarely freezes?
If your area only gets a few light frosts, you might get away with leaving the barrel partially full, but it’s not worth the risk. A single hard freeze can crack it. Drain and store it as described—it takes less than an hour and gives you peace of mind.